tv unit with cnc design

tv unit with cnc design

tv unit with cnc design

This is simple tv unit with cnc design for celling touch and 12mm mdf CNC 

in which you can put plywood behind the TV so that the TV can be fitted. Ease of areas and it is strong.

In this, according to your place. you can increase the size of the TV unit.

put a leg of 4 inches under it so that it does not spoil with water and runs more.

You can also rotate this design in the ceiling so that it looks rotating and looks good.

Apart from this design, you can get the design of flower leaves cut.

tv unit size

It has a height of 18 inches at the bottom of the box and a 6-inch box at the top which is open.

The setup box DVD remote can hold it.

The bottom is a drawer and the top is a 6-inch frame with a 12 mm MDF inside. 6 mm acrylic behind it.

The seat is equipped with a tubelight behind the acrylic sheet so that the 12mm MDF design shows the light. 

You can also take this design a little bit, so that the design of flower leaves can be slightly bigger and look better in appearance.

Inside this design, you should install the tubelight according to the requirement.

so that the design looks perfect, in addition to this you can also replace the tubelight with LED light.

You can use different color LED lights, this is a simple TV unit.

it will not cost you much and you can make a good TV unit at a lower cost.

If you find space to store more stuff then you can also make a box bigger it A lot of luggage  will sit in it.   

What color to use in tv unit with cnc design 

you will use white and dark sunmica.

white sunmica is placed in the open box  and  other place apply dark sunmica.

Buy onlinehttps://www.urbanladder.com

Leave a Comment

Your email address will not be published. Required fields are marked *